2026-08-12T09:34:02+03:30 http://ijeee.iust.ac.ir/browse.php?mag_id=6&slc_lang=en&sid=1

6-45 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 H. Mahdavi-Nasab Shohreh Kasaei Motion estimation and compensation is an essential part of existing video coding systems. The mesh-based motion estimation (MME) produces smoother motion field, better subjective quality (free from blocking artifacts), and higher peak signal-to-noise ratio (PSNR) in many cases, especially at low bitrate video communications, compared to the conventional block matching algorithm (BMA). However, the iterative refinement process of MME is computationally much costly and makes the method impractical in real- (or near real-) time systems. Also, eliminating the iterative refinement step deteriorates the motion estimation result. In this paper, we propose motion adaptive interpolation schemes for noniterative MME, which use BMA to compute the motion vectors (MVs) of mesh nodes. The proposed algorithm aims at compromising the MME and BMA by modifying the interpolation patterns (IPPs) of the MME in an adaptive manner, based on the MVs of mesh nodes. Experimental results show notable rate-distortion improvement over both BMA and conventional non-iterative MME, with acceptable visual quality and system complexity, especially when applied to sequences with medium to high motion activities. Motion Estimation Block Matching Mesh-Based Analysis Low Bitrate Video Coding Interpolation 2005 4 01 49 58 http://ijeee.iust.ac.ir/article-1-45-en.pdf

6-46 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 S.M.Reza Soroushmehr Shadrokh Samavi Shahram Shirani In this paper a new method for determining the search area for motion estimation algorithm based on block matching is suggested. In the proposed method the search area is adaptively found for each block of a frame. This search area is similar to that of the full search (FS) algorithm but smaller for most blocks of a frame. Therefore, the proposed algorithm is analogous to FS in terms of regularity but has much less computational complexity. To find the search area, the temporal and spatial correlations among the motion vectors of blocks are used. Based on this, the matched block is chosen from a rectangular area that the prediction vectors set out. Simulation results indicate that the speed of the proposed algorithm is at least 7 times better than the FS algorithm. Block Motion Estimation Search Area Temporal Correlation Spatial Correlation Motion Vector 2005 4 01 59 67 http://ijeee.iust.ac.ir/article-1-46-en.pdf

6-47 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 H. Monsef N.T. Mohamadi Electric power restructuring offers a major change to the vertically integrated monopoly. The change manifests the main part of engineers’ efforts to reshape the three components of today’s vertically integrated monopoly: generation, distribution and transmission. In a restructured environment, the main tasks of these three components will remain the same as before, however, to comply with FERC orders, new types of unbundling, coordination and rules are to be established to guarantee competition and non-discriminatory open access to all users. This paper provides the generation schedule of a GENCO in a deregulated power system. It is shown that the goal of generation schedule in the new structure is different from the traditional centralized power systems. The modeling of generation scheduling problem in a competitive environment is demonstrated by taking into account the main purposes of GENCOs which are selling electricity as much as possible and making higher profit. The GENCOs of an area are introduced via a model whose objective function consists of hourly spot market price as income and different kinds of costs. The constraints are the general ones of such a problem e.g. minimum up/down time, minimum and maximum generation and ramp rate. Using one of the classical optimization methods, the hourly generation schedule of the generating units will be obtained in this competitive environment. The results of this section will be used by ISO. The ISO will finalize the schedules of GENCOs by taking into account the technical considerations like the power flow of transmission lines. The model and the optimization methods are implemented on IEEE-RTS benchmark with 24 buses and 32 generating units. Generation Scheduling Competitive Environment Miexed Integer Programming Linear Programming 2005 4 01 68 73 http://ijeee.iust.ac.ir/article-1-47-en.pdf

6-48 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 S.Jadid S.Jalilzadeh This paper presents a new composite index to analyze power system transient stability. Contingency ranking in power system transient stability is a complicated and time consuming task. To prevail over this difficulty, various indices are used. These indices are based on the concept of coherency, transient energy conversion between kinetic and potential energy and three dot products of the system variables. It is well known that some indices work better than others for a particular power system. This paper along with test results using two practical 230 kV Sistan and 400 kV Khorasan power system in Iran, and 9 bus IEEE test system demonstrates that combination of indices provides better ranking than a single one. In this paper two composite indices ( CI ) is presented and compared. One composite index is based on Least Mean Square algorithm (LMS) and other based on summing indices by equal weights. Numerical simulations of the developed index, demonstrate that composite index is more effective than other indices. Composite Index Transient Stability Energy Margin 2005 4 01 74 80 http://ijeee.iust.ac.ir/article-1-48-en.pdf

6-49 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 A.Vahedi M.Ramezani Dc excitation of the field winding in a synchronous machine can be provided by permanent magnets. Permanent magnet synchronous machine (PMSM) can offer simpler construction, lower weight and size for the same performance, with reduced losses and higher efficiency. Thanks to the mentioned advantages these motors are widely used in different application, therefore analysis and modeling of them, is very important. In this paper a new, fast and simple method is presented to study performance of a PMSM connected to the converter. For this purpose, average-value modeling and related analytical relations which leads to the desired characteristics such as electromagnetic torque, dc current and dc voltage is presented and applied to PMSM & converter system. The advantage of this model lie in reduction of computation time compares to the other dynamic models while keeping accuracy quite acceptable. This model is applicable for studying the steady-state performance of systems as well as dynamic performance. Average-Value Modeling Permanent Magnet Synchronous Machine (PMSM) Converter Commutation 2005 4 01 81 87 http://ijeee.iust.ac.ir/article-1-49-en.pdf

6-50 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 A Ayatollahi N Jafarnia Dabanloo DC McLernon V Johari Majd H Zhang Developing a mathematical model for the artificial generation of electrocardiogram (ECG) signals is a subject that has been widely investigated. One of its uses is for the assessment of diagnostic ECG signal processing devices. So the model should have the capability of producing a wide range of ECG signals, with all the nuances that reflect the sickness to which humans are prone, and this would necessarily include variations in heart rate variability (HRV). In this paper we present a comprehensive model for generating such artificial ECG signals. We incorporate into our model the effects of respiratory sinus arrhythmia, Mayer waves and the important very low frequency component in the power spectrum of HRV. We use the new modified Zeeman model for generating the time series for HRV, and a single cycle of ECG is produced using a radial basis function neural network. ECG Neural Networks Heart Rate Variability Dynamical Systems 2005 4 01 88 93 http://ijeee.iust.ac.ir/article-1-50-en.pdf

6-51 2026-08-12 10.1002

Iranian Journal of Electrical and Electronic Engineering IJEEE 1735-2827 1735-2827 2005 1 2 F. Hojjat Kashani A. A. Lotfi Neyestanak K. Barkeshli A modified circular patch antenna design has been proposed in this paper, the bandwidth of this antenna is optimized using the genetic algorithm (GA) based on fuzzy decision-making. This design is simulated with HP HFSS Program that based on finite element method. This method is employed for analysis at the frequency band of 1.4 GHz- 2.6 GHz. It gives good impedance bandwidth of the order of 15.5% at the frequency band of 1.67GHz- 1.95GHz and 10.6% at 2.23GHz- 2.48GHz. It means that impedance bandwidth increases above 4.9% than the impedance bandwidth of ordinary circular patch antennas and band width rise from 1.78GHz- 1.98GHz (10.6%) to 1.67GHz- 1.95GHz (15.5%) and 2.23GHz- 2.48GHz (10.6%). The antenna fabricated with two slots on circular patch antenna. The measured results of the optimized antenna validate a high compatibility between the simulation and the measurements. E-Shaped Circular Patch Antenna Genetic Algorithm Fuzzy System Wide Band Antenna 2005 4 01 94 101 http://ijeee.iust.ac.ir/article-1-51-en.pdf