Volume 16, Issue 1 (March 2020)                   IJEEE 2020, 16(1): 48-57 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Mohamadian S, Azizi Moghaddam H. Conduction and Dead-Time Voltage Drops Estimation of Asymmetric Cascaded H-Bridge Converters Utilizing Level-Shifted PWM Scheme. IJEEE 2020; 16 (1) :48-57
URL: http://ijeee.iust.ac.ir/article-1-1500-en.html
Abstract:   (2972 Views)
Linear AC power supplies can be replaced by their nonlinear switching counterparts due to the lower voltage drops and higher efficiency and power density of switching-mode inverters. Multilevel cascaded H-bridge (CHB) converters are the preferred inverter structure because of modular configuration, control, and protection. The output voltage quality in CHB converters depends on the number of output levels. Asymmetric CHBs (ACHBs) produce an output voltage with higher number of levels with respect to CHBs for the same number of cascaded modules. This results in the reduction of power supply size, voltage drops, and losses. Considering the relative high switch counts, analysis of the effect of conduction and dead-time voltage drops on the inverter output characteristics is an important challenge in designing multilevel converters. In this paper, a generic algorithm is presented to calculate the conduction and dead-time voltage drops of ACHBs utilizing level-shifted modulation. These voltage drops give the necessary information for the design of heatsinks, switch selection, output impedance estimation, and the compensation schemes. It is shown through theoretical and simulation studies that the aforementioned voltage drops of ACHBs are to be calculated in a different manner with respect to the CHBs which mostly use the phase-shifted modulation.
Full-Text [PDF 1141 kb]   (1566 Downloads)    
  • A generic approach is presented for the estimation of conduction and dead-time voltage drops in multilevel asymmetric CHB converters.
  • It is shown that, unlike the conventional CHB converters which use the phase-shifted PWM, the aforementioned voltage drops are to be computed in a different manner in level-shifted PWM.
  • The output impedance of the generic ACHB is also computed.

Type of Study: Research Paper | Subject: Industrial Electronics
Received: 2019/05/11 | Revised: 2019/11/26 | Accepted: 2019/11/29

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Creative Commons License
© 2022 by the authors. Licensee IUST, Tehran, Iran. This is an open access journal distributed under the terms and conditions of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY-NC 4.0) license.